Use and Care Manual

OPEN BED FRAME
READY
ASSEMBLE
TO
Page 2 of 2
Attach 2 slat kits (5) to the open bed frame as shown below using wood screws 1 1/4" (D).
Tighten with Phillips head screw driver. (customer supplied)
Step 6
E
F
D
D
F
F
Congratulations!
Your bed is now ready for use.
D
Wood screw 1 1/4"
5
5
6
7
E
E
F
F
E
E
If using a Trundle Bed attach slat supports off
center as shown.
E F
JCB M6 X 25mm Cap nut
5
5
D
Step 3 Step 4
Step 5
G
G
G
Allen screw
JCB M8 X 15mm
6
8
8
8
7
G
Attach open bed frame to the headboard
as shown below using 4 JCB M8 X 15mm bolts
that are supplied with your headboard.
Tighten with the Allen wrench M6 (E).
Attach support legs (8) to slat support 1 & 2 (6)(7) as
shown below. Using allen screw (G) tighten with
Allen wrench M4 (I).
Attach slat support 1(6) and slat support 2 (7) to the slat kit (5) as shown below
using JCB M6 X 25mm (E) and cap nut (F). Tighten with Allen wrench M4 (I).
We recommend that you periodically recheck that all screws are tight to ensure lasting safety.
2 legs at headboard section.
1 leg at footboard section.