Instruction manual
16 17
A Open HARDWARE FOR STEP 6. Remove zip tie
securing axle in LOWER LINK ARM.
B Align end of LOWER LINK ARM with bracket on
bottom of LOWER HANDLEBAR.
C Place TEFLON WASHERS (X) on both sides of
the LOWER LINK ARM. While holding TEFLON
WASHERS (X) slide LOWER LINK ARM into bottom
end of LOWER HANDLEBAR.
D Secure the joint with 1 FLAT WASHER (Y), 1
SPRING WASHER (B),1 BOLT (Z) and secure with
1 NUT (AA).
E Repeat steps B–D on the opposite side of the
elliptical.
SPRI NG WASHER (B)
15 mm
Qty: 2
TEFLON
WASHER (X)
28.4 mm
Qty: 4
FLAT WASHER (Y)
17 mm
Qty: 2
NUT (AA)
Qty: 2
BOLT (Z)
70 mm
Qty: 2
HARDWARE FOR STEP 6 :
BOLT (Z)
FLAT WASHER (Y)
NUT (AA)
LOWER HANDLEBAR
SPRING WASHER (B)
TEFLON WASHERS (X)
LOWER LINK ARM
ASSEMBLY STEP 6
4.1AE SHOWN
ASSEMBLY STEP 7
WATER BOTTLE HOLDER
TOP CAP REAR COVERCONSOLE MAST
CONSOLE MAST BOOT
TOP CAP
SCREWS (BB)
SCREWS (CC) REAR CAP
REAR STABILIZER
A Open HARDWARE FOR STEP 7.
B Slide TOP CAP and TOP CAP REAR COVER
over CONSOLE MAST and snap into place.
C Insert CONSOLE MAST BOOT over TOP CAP
and snap into place.
D Slide WATER BOTTLE HOLDER over
CONSOLE MAST and attach using 2
SCREWS (BB).
E Slide REAR CAP over REAR STABILIZER and
attach using 2 SCREWS (CC).
HARDWARE FOR STEP 7 :
SCREW (BB)
20 mm
Qty: 2
SCREW (CC)
15 mm
Qty: 2
4.1AE SHOWN
NOTE: Be careful not to pinch any
wires while tightening screws.
$(B$(B20B5HYBLQGG $0