Instruction manual
12 13
ASSEMBLY STEP 2
A Open HARDWARE FOR STEP 2.
B Attach the GUIDE RAIL SET to the
MAIN FRAME using 4 BOLTS (F), 4
SPRING WASHERS (E) and 4 FLAT
WASHERS (D).
C Attach the GUIDE RAIL SET to the
INCLINE BRACKET using 4 BOLTS
(G), 4 FLAT WASHERS (H), 4 SPRING
WASHERS (I) and 4 NUTS (J).
SPRI NG WASHER (E)
15 mm
Qty: 4
FLAT WASHER (D)
16 mm
Qty: 4
BOLT (F)
20 mm
Qty: 4
SPRI NG WASHER (I)
18 mm
Qty: 4
FLAT
WASHER (H)
20 mm
Qty: 4
BOLT (G)
35 mm
Qty: 4
NUT (J)
Qty: 4
HARDWARE FOR STEP 2 :
FLAT WASHERS (D)
SPRING WASHERS (E)
BOLTS (F)
FLAT WASHERS (H)
SPRING WASHERS (I)
NUTS (J)
GUIDE RAIL SET
INCLINE BRACKET
MAIN FRAME
BOLTS (G)
4.1AE SHOWN
BOLT (O)
SPRI NG WASHER (B)
FLAT WASHER (K)
WAVY WASHE R (N)
PEDAL ARM
CRANK
PEDAL ARM WHEEL
GUI DE RAIL
CONSOLE MAST
BOLTS (L)
CONSOLE CABLE
MAIN FRAME
FLAT WASHERS (M)
ASSEMBLY STEP 3
A Open HARDWARE FOR STEP 3.
B Carefully pull the CONSOLE CABLE through
the CONSOLE MAST using the twist tie located
inside the CONSOLE MAST.
C Attach CONSOLE MAST to MAIN FRAME
using 4 FLAT WASHERS (M) and 4 BOLTS (L).
D Slide WAVY WASHER (N) over CRANK
followed by PEDAL ARM as shown. Rest
PEDAL ARM WHEEL on GUIDE RAIL.
E Attach the PEDAL ARM to the CRANK using 1
FLAT WASHER (K), 1 SPRING WASHER (B)
and 1 BOLT (O).
F Repeat steps D–E on the opposite side of the
elliptical.
BOLT (O)
20 mm
Qty: 2
SPRI NG WASHER (B)
15 mm
Qty: 2
FLAT WASHER (K)
20 mm
Qty: 2
WAVY WASHE R (N)
22.5 mm
Qty: 2
FLAT WASHER (M)
23 mm
Qty: 4
BOLT (L)
15 mm
Qty: 4
HARDWARE FOR STEP 3 :
NOTE: Be
careful not
to pinch any
wires while
attaching the
console mast.
4.1AE SHOWN
$(B$(B20B5HYBLQGG $0