Instruction manual
10 11
TOOLS INCLUDED:
F 8 mm L-Wrench
F 5 mm L-Wrench
F 13/15 mm Flat Wrench
F Screwdriver
F 5 mm L-wrench/Screwdriver
PARTS INCLUDED:
F 1 Stabilizer Tube
F 1 Guide Rail Set
F 2 Pedal Arms
F 2 Lower Handlebars
F 2 Upper Handlebars
F 2 Lower Link Arms With Footpads
F 1 Top Cap (2 pieces)
F 1 Console Mast
F 1 Console Mast Boot
F 1 Console
F 2 Handlebar Caps
F 1 Water Bottle Holder
F 1 Rear Cover
F 1 Audio Adapter Cable
F 1 Power Cord
F 1 Hardware Kit
3.1AE only:
F 2 Handlebar Boots
4.1AE only:
F 2 Handlebar Covers
F 2 Aero Hand Grips
F 1 iPod
®
Dock Rubber Plug
F 1 Polar
®
Chest Strap
UNPACKING
Unpack the product where you will be using it. Place the elliptical carton on a level
flat surface. It is recommended that you place a protective covering on your floor.
Never open box when it is on its side.
NOTE: During each assembly step, ensure that ALL nuts and bolts are in place
and partially threaded in before completely tightening any ONE bolt.
NOTE: A light application of grease may aid in the installation of hardware. Any
grease, such as lithium bike grease is recommended.
If you have questions or if
there are any missing parts,
contact Customer Tech
Support. Contact information
is located on the back panel
of this manual.
NEED HELP?
PRE ASSEMBLY
ALL
MODELS
ASSEMBLY STEP 1
A Open HARDWARE FOR STEP 1.
B Attach the STABILIZER TUBE to the MAIN
FRAME using 2 BOLTS (A), 2 SPRING
WASHERS (B) and 2 ARC WASHERS (C) on
each side.
BOLT (A)
30 mm
Qty: 4
SPRING WASHER (B)
15 mm
Qty: 4
ARC WASHER (C)
17 mm
Qty: 4
HARDWARE FOR STEP 1 :
BOLTS (A)
SPRING WASHERS (B)
ARC WASHERS (C)
STABILIZER TUBE
MAIN FRAME
ALL
MODELS
$(B$(B20B5HYBLQGG $0