Specifications

Syntax and Commands
AFG3000 Series Arbitrary/Function Generators Programmer Manual 2-57
[SOURce[1|2]]:FREQuency:STARt
This command sets or queries the start frequency of sweep for the specified
channel. This command is always used with the
[SOURce[1|2]]:FREQuency:STOP command. The setting range of start frequency
depends on the waveform selected for sweep. For more information on the setting
range, refer to the specifications page of Quick Start User Manual.
Group
Source
Related Commands
[SOURce[1|2]]:FREQuency:MODE
[SOURce[1|2]]:FREQuency:STOP
Syntax
[SOURce[1|2]]:FREQuency:STARt {<frequency>|MINimum|MAXimum}
[SOURce[1|2]]:FREQuency:STARt? [MINimum|MAXimum]
Arguments
<frequency>::=<NRf>[<units>]
where
<NRf> is the start frequency.
<units>::=[Hz | kHz | MHz]
Returns
<frequency>
Examples
SOURce1:FREQuency:STARt 10kHz
sets the sweep start frequency of CH 1 to 10 kHz.