User`s guide

BEFORE
YOU BEGIN
ASSEMBLYASSEMBLY
15
INTRODUCTION
IMPORTANT
PRECAUTIONS
TREADMILL
OPERATION
CONDITIONING
GUIDELINES
TROUBLESHOOTING
& MAINTENANCE
LIMITED
WARRANTY
ASSEMBLY
BEFORE
YOU BEGIN
IMPORTANT
PRECAUTIONS
PROPER USAGE
Your treadmill is capable of reaching high speeds. Always start off using a slower speed and adjust the speed in
small increments to reach a higher speed level. Never leave the treadmill unattended while it is running. When
not in use, remove the safety key and keep out of reach of children, turn the on/off switch to off and unplug
the power cord. Make sure to follow the MAINTENANCE schedule located in this manual. Keep your body and
head facing forward. Do not attempt to turn around or look backwards while the treadmill is running. Stop your
workout immediately if you feel pain, faint, dizzy or are short of breath.
Do not operate the treadmill if the power cord or plug is damaged.
If the treadmill appears to not be working properly, do not use the treadmill.
FOLDING
Firmly grasp the back end of the treadmill. Carefully lift the end of the
treadmill deck into the upright position until the foot lock latch engages
and securely locks the deck into position. Make sure the deck is securely
latched before letting go. To unfold, firmly grasp the back end of the
treadmill. Gently press down on the foot lock latch with your foot until the
lock latch disengages. Carefully lower the deck to the ground.
MOVING
Your treadmill has transport wheels built into the frame. To move,
make sure the treadmill is folded and securely latched. To unlock
wheels, push down on the top lever of the rear wheel locks located on
the rear corners of the base frame. Then firmly grasp the handlebars,
and slowly move the treadmill. After moving to the desired location,
push down on the bottom lever of the rear wheel locks to lock the
rear wheels.
NOTE: Both rear wheel locks MUST be locked before using the
treadmill.
Our treadmills are heavy, use care and additional help if necessary when moving.
Do not attempt to move or transport treadmill unless it is in the upright, folded
position with the lock latch secured. Do not attempt to disassemble machine and
transport. Failure to follow these instructions could result in injury.
POWER
The power cord must be plugged into the power jack, which is located in the front of the machine below the
MOTOR COVER. Make sure the power switch is in the ON position. After use, the power switch should be turned
to the OFF position.
WARNING
WARNING
WHEEL LOCKS