User`s guide

16
INTRODUCTION
IMPORTANT
PRECAUTIONS
ASSEMBLY
BEFORE
YOU BEGIN
CONDITIONING
GUIDELINES
TROUBLESHOOTING
& MAINTENANCE
LIMITED
WARRANTY
17
INTRODUCTION
IMPORTANT
PRECAUTIONS
ASSEMBLY
BEFORE
YOU BEGIN
CONDITIONING
GUIDELINES
TROUBLESHOOTING
& MAINTENANCE
LIMITED
WARRANTY
Open HARDWARE BAG 9.
Remove NUT, WASHERS, SCREW, HOOK, CLEVIS and BALL STOP from the end of CABLE D.
Install CABLE D as shown in diagram.
After CABLE D routing is complete replace BALL STOP, CLEVIS, HOOK, SCREW, WASHERS
and NUT on end of cable.
NOTE: Ensure the “O” RING is positioned at the end of CABLE D against the BALL STOP.
Attach CABLE D to PRE-ATTACHED LEG ExTENSION CABLE.
A
B
C
D
E
ASSEMBLY STEP 9
CABLE D
Qty: 1
HARDWARE BAG 9 CONTENTS :
CABLE DCABLE D
SINGLE FLOATING
PULLEY BRACKET
PRE-ATTACHED LEG EXTENSION CABLE
DUAL FLOATING
PULLEY BRACKET
YOU’RE FINISHED!
ASSEMBLY STEP 10
Open HARDWARE BAG 10.
Install WEIGHT SHROUDS as shown in diagram, using 8 BOLTS (R).
A
B
BOLT (R)
10 mm
Qty: 8
HARDWARE BAG 10 CONTENTS :
WEIGHT
SHROUD
WEIGHT
SHROUD
UPPER MOUNTING
BRACKET
BOLT (R)
LOWER MOUNTING
BRACKET
2.0AS_Rev.1.5.indd 16-17 9/23/08 10:15:07 AM