Owner`s manual

2008 AFG Service Seminar [rev 1.3] | 67
Section Three | Troubleshooting
Elliptical | Bike Troubleshooting
>> Alignment Issues with Pedal Arms
Symptom Possible Cause Test Procedure Repair
Noise externally while
pedaling, rough feel
while pedaling, or (for
elliptical only) the pedal
arm will jump off of
guide rail.
Improper assembly or
loose assembly bolts.
-Verify assembly steps
using owner’s guide.
Tighten all bolts used
for assembly. Reference
Maintenance p20 and
p21.
Loose crank arms. Tighten crank arms.
Alignment issues with
pedal arms due to
improper welds.
-Disconnect
appropriate link arm
from lower handle bar
assembly and pedal
unit.
- If the noise ceases or
pedal does not jump
off guide rail replace
handlebar.
- If there is no change
replace link arm, pedal
arm, and crank.