Owner`s manual
62 | 2008 AFG Service Seminar [rev 1.3]
Section Three | Troubleshooting
Elliptical | Bike Troubleshooting
>> Noise | Drive Train Continued
Symptom Possible Cause Test Procedure Repair
Noise internally/
externally while
pedaling or rough feel
while pedaling.
(Continued)
Failed pedal axle set. There might be a
persistent grinding
noise or knocking with
every pedaling motion.
The noise usually
presents itself only once
during each rotation.
Replace pedal axle set.
Defective pivot tube. -Remove pedal arm and
spin pivot tube to see if
noise is still there.
Replace Pivot Tube(s).
Clicking noise in front of
foot pad on Mini-E.
-Remove foot pad and
tighten bolt.
Replace pivot block
bushing, bolt and nut.
Gap between front
stabilizer and elliptical
frame.
Check to see if there is
a large gap between the
front stabilizer and
elliptical frame.
Tighten bolts. If gap is
still present use exible
Teon washers to ll the
space.
Flywheel defective
(Bike Only).
-Verify the noise
continues a few seconds
after the pedal stops
moving.
Replace the Flywheel.