Owner`s manual

2008 AFG Service Seminar [rev 1.3] | 31

Section Two | Adjusting the Magnetic Break

>> Adjusting the Magnetic Break

Tools Required:

• Phillips Screwdriver

• 8mm, 13mm, 17mm Socket and Combination Wrenches

• 5mm Allen Wrench

• Crank Puller

Procedure:

1 | Turn on unit and Press start.

2 | Set resistance highest level and power off unit.

3 | Remove side covers.

4 | Loosen the short nut (A), and adjust the long nut (B) clockwise to reduce the brake resistance and

counterclockwise to increase the brake resistance.

The correct position for the ywheel/brake assembly is 1-2 mm from the ywheel at the

highest resistance level.