Owner`s manual

2008 AFG Service Seminar [rev 1.3] | 11
Section One | Safety Instructions
During the assembly process there are several areas that special attention must be paid. It is very
important to follow the assembly instructions correctly and to make sure all parts are firmly tightened. If
the assembly instructions are not followed correctly, the home gym could have frame parts that are not
tightened and will seem loose and may cause irritating noises. There should be no side-to-side play in
the frame uprights. If there is any play in these areas, the home gym has not been properly assembled.
To prevent damage to the home gym, the assembly instructions must be reviewed and corrective actions
should be taken.
UNPACKING
Unpack the unit where it will be used. Place the home gym carton on a level flat surface.
It is recommended that you place a protective covering on your floor. Take CAUTION when handling and
transporting this unit. Never open box when it is on its side.
FAILURE TO FOLLOW THESE INSTRUCTIONS COULD RESULT IN INJURY!
PROPER USAGE
Make sure to follow the MAINTENANCE schedule in this manual. Stop your workout immediately if you
feel pain, faint, dizzy or are short of breath. Reference Home Gym Maintenance p22.
SEAT ASSEMBLY PIN
Ensure that the seat assembly safety pin is fully inserted before using the home gym.
Failure to do so may result in injury!
WARNING
WARNING
Do not operate the home gym if there is any noticeable damage to the cables or pulleys.
If any damage is noticeable, contact AFG at the number located on the back panel of
this manual.
Safety Instructions
>> Gym Continued