Owners manual

2 Revised 6-22-2017 00P-0T1044-A
Front OEM Strut Removal
1. Using proper jacking points, lift and support the front of the car on jack stands.
2. Using a 22mm socket remove the front wheels.
3. Using a 18mm wrench and 7/32 allen wrench, disconnect the sway bar link at the sway bar, it is
not necessary to disconnect at the strut.
4. Position a screw, or floor jack under the front control arm to hold in place.
5. Unbolt the clip that attaches the brake line to the strut using a 10mm socket.
6. Using a 21 mm socket and 15/16 wrench, remove the 2 bolts that holds the OEM strut into the
upright. Slowly lower the jack and slide strut free from upright.
7. If the vehicle is equipped with Selective ride you will need to disconnect the connector before
removing the OEM strut from the vehicle.
8. Using a 13 mm socket, remove the (3) bolts that hold the strut housing into the vehicle. Be careful
to use a helper to hold the strut from the bottom of the car.