Owners manual

9959 04/22/2016
FIGURE 12-2
FIGURE 12-3
13. R
eplace the wheels. Tighten the lug nuts to factory torque specifications and set t
he
v
ehicle on the ground. Inspect the ride height.
14. If you are happy with the achieved lift you are done. If the lift is too much loosen the coil
spring adjuster. If the lift is not enough tighten the coil spring adjuster. Repeat until yo
u
hav
e achieved the desired lift. Remember to loosen setscrew and lift the vehicle back
up
w
ith a jack if adjusting the height and also to tighten the setscrew when all adjusting has
been completed. It is not recommended to lift the vehicle more than 2.5”. After you have
finished installing your suspension kit, you must have the front end aligned.