Owners manual

ManualsBrandsAFE Filters ManualsAutomotive101-5600-07 Sway-A-Way Front Coilover Kit Fits 96-02 4Runner

9959 04/22/2016

191 Granite St, Corona, CA 92879

Phone # 888-901-7693

afepower.com/swayaway

Tacoma/Tundra/4-Runner/Sequoia/Sway-A-Way

Front Coilover Installation

Parts List

-2 Sway-A-Way Coilover Shocks

Tool List

-5/32” Allen wrench

-9/16” wrench or socket (Sway-A-Way spring hat)

-14mm wrench or socket (OEM spring hat)

-19mm wrench and deep socket (Lower front shock bolt and OEM U-Bolts)

-21mm socket (lug nuts)

-Jack and jack stands

-Spanner wrench (included)(PN 50003-202)

-Impact wrench

Summary of content (5 pages)

PAGE 1
91 Granite St, Corona, CA 92879 Phone # 888-901-7693 afepower.
PAGE 2
Removal and Installation Procedure for Front Coilovers (Shocks come pre-charged direct from the factory with 200 PSI of Nitrogen) 1. Park the vehicle on a level concrete surface where it is safe to work on your vehicle. 2. Lock and center the steering wheel. 3. Place blocks in front and behind the rear tires so as to keep the vehicle from moving forwards or backwards. 4.
PAGE 3
8. Using a 14mm and 19mm wrench or socket remove the bolt (14mm) and nut (19mm) from the lower shock mount. Remove the entire shock assembly from the truck. Remember to save the lower shock mount bolt and nut. 9. To install your new Sway-A-Way shocks align the upper shock mount inside the stock coil housing with the Schrader valve facing outwards and loosely secure with the supplied 3/8” bolts and lock washers. 10.
PAGE 4
11. Using 9/16” wrench or socket torque the new spring hat 3/8”bolts to 25ft lbs and the lower shock mount bolt (14mm) to 50ft lbs using a 19mm wrench or socket. 12. After having secured the shock to the lower arm you can set the initial ride height. Do steps 6 to 11 for the removal and installation of shock on other side. 12. When you are done installing the coilovers now it is time to check the brake line clearance.
PAGE 5
FIGURE 12-2 FIGURE 12-3 13. Replace the wheels. Tighten the lug nuts to factory torque specifications and set the vehicle on the ground. Inspect the ride height. 14. If you are happy with the achieved lift you are done. If the lift is too much loosen the coil spring adjuster. If the lift is not enough tighten the coil spring adjuster. Repeat until you have achieved the desired lift.