Owners manual

9956-1 2010+ FJ Cruiser Front 04/16 (Rev B)
Removal and Installation Procedure for Tacoma Front
(Shocks are already charged with 200 PSI of Nitrogen)
1. Park the vehicle on a level concrete surface where it is safe to work on your vehicle.
2. Lock and center the steering wheel.
3. Place blocks in front and behind the rear tires so as to keep the vehicle from moving
forwards or backwards.
4. It is beneficial that you get a reference measurement of the stock ride height prior to the
removal of the stock coil-overs; measuring the distance from the center of the hub to the
bottom of the fender does this. You will use this measurement when you are setting your
ride height after installation.
5. Using a jack lift the front of the vehicle and support the vehicle using jack stands. Be sure
to place the jack and jack stands securely in the positions shown in the diagram. After
placing the jack stands slowly lower the jack and remove the jack so that the front
suspension can hang freely. Remember to be alert and cautious when working under a
vehicle.
6. Remove the front wheels and set them aside.
7. Remove the safety pin from the tie-rod end nut. Using a 17mm wrench or a socket
remove the tie rod end nut.