Technical data

Xtreme Pag. 25
Electronic Broadcast Equipment
Sec. 8 Technical Data
PERFORMANCE
Frequency response 30Hz ÷ 15 KHz
(measured below compression and clipping THR)
Stop band rejection > 78 dB beyond 17 KHz
Noise > 75 dB in all conditions
(depends on the processing parameters)
Total distortion < 0,01 %
Total system separation > 85 dB (30 Hz – 15 kHz)
ANALOG AUDIO INPUT
Configuration Left and Right
Impedance 10 Kohm
CMRR > 45 dB from 30 to 15 Khz
Sensitivity ±12dBu
Maximum input level +16 dBu
Connector XLR-type, female, EMI suppressed
Pin 1 Chassis
Pin 2 & 3 electronically balanced, floating and symmetrical
ANALOG AUDIO OUTPUT
Configuration Left and Right. Flat or pre-emphasized (50µS – 75µS)
Impedance 30 Ohm electronically balanced and floating
Minimum load impedance 600 Ohm
Maximum output level +12 dBu into 600 ohm load
Connector XLR-type, male, EMI suppressed
Pin 1 Chassis
Pin 2 & 3 electronically balanced, floating and symmetrical
STEREO GENERATOR
Configuration Two outputs independent
Pilot freq. 19 KHz ± 0.001% Max over temp.
Pilot injection +4 ÷ 12 %
Distortion < 0.005 % @1 kHz
Noise signal ratio 70 dB (Din Audio,Bypass mode) Typical
Stereo separation 60 dB Typical