User manual

89
Terminals status during a MCU
A. Status of MCU manager
By selecting the Conference Status icon a window will appear, with information
about connection settings of local terminal.
It’s moreover possible to:
 Select Duration icon to access MCU timing management page
• It’s possible to select No time limits or a time for MCU conclusion
• Close Now will immediately close the MCU
• OK to confirm choices
• Cancel to discard changes
B. Status of MCU “Terminal n.”
By selecting the Conference Status icon a window will appear, with information
about connection settings of terminal, number of connected remote terminals,
kind of call (outgoing/incoming), terminal number.
It’s moreover possible to:
 Select the i icon, with connected terminals only, to visualize connection diagnostics
 Choose between Always accept or Refuse incoming IP or ISDN calls, with disconnected
terminals only.
 Choose
Control Number for ISDN, to insert the only number allowed to join the conference
for that terminal.
 The
OK icon closes the page.
Ending a Multiconference
There are two ways to end a multiconference:
A) From the full-screen video page, press the remote control DISCONNECT key
• The Cancel icon closes the page without performing any operation
• By means of arrow keys UP and DOWN you can select and disconnect a
participant
• Close Now icon will immediately close the whole MCU (disconnection of
all terminals)
B) From the multiconference management interface, select the Menu icon on the status bar and press
OK.
In both cases the System shows:
• A message asking confirmation for the multiconference end
• A message asking whether to save in the Phonebook all information needed
to repeat the multiconference, with an editable Conference name