User manual

84
H.243 function
From the full screen page of MCU manager or a participant terminal is possible to get
MCU control, conforming to H.243 protocol, by pressing the BLUE key.
A page will appear, where is possible to:
 Request Chair control.
• Close conference.
 Send local on air.
 For each terminal in the list.
•
Information: connected users.
• See.
• Send on air.
• Disconnect.
Remote terminals disposition and visualization
“Terminals disposition” icon
“Video Zoom +” icon
“Video Zoom -” icon
With MCU on and various connected terminals, is possible to choose disposition and
how many video flows should be displayed. From the full screen page of the manager,
press right or left keys to select the “terminals disposition” icon, and press OK.
Once the window is opened:
1. By means of up and down keys choose the visualization mode, and then confirm selection
with OK key.
2. Close the window by means of the OK icon, or with the X icon to discard selection.
Note
If Continuous Presence transmission is enabled in configuration (see Multiconference setup
chapter), “terminal disposition” is sent to all terminals