User manual



Mode (only for MCU ISDN or Mixed)

Multiple of 64K

Multiple of 56K.

 Cascade Role, Master or Slave

This option allows you to set up cascaded MCUs in a two-level hierarchy tree.

Corresponding to the base node of the cascade there is the Master System,

with Slave Systems for the child nodes.

Note

In a mixed-mode MCU session, the user can choose to substitute NIC protocol for ISDN.

So in a multiconference with an active NIC connection, no ISDN connections are allowed,

and in a multiconference with an active ISDN connection, no NIC connections are allowed.

How to start a multiconference

To establish a multiconference:

1. From the HOME PAGE, select the VIDEO icon, or press the Call key on the

remote control. You will enter the AUDIO AND VIDEO CALL page.

2. Choose desired MultiConference type: MCU IP, MCU ISDN, MCU (mixed

mode).

3. Chose the desired rate and number of participants.

4. If the MCU has not been configured, it is possible to enter the configuration

menu previously described by selecting the CONFIGURE MCU icon and

pressing OK.

5. If the MCU has already been configured, go to the Active Conference icon

and press OK to start the multiconference. The same can be obtained by

pressing the CALL key on the remote control.

6. Local video will be displayed at full screen.

7. To add participants, press the remote control CALL key

8. To disconnect participants, press the remote control DISCONNECT key.