User manual

53
Plasma/LCD
Select plasma, type of monitor and viewing modality.
Note: The follows instructions refers to “Pioneer” monitors.
!
Please carefully check XGA, Y/C and RS232C/DEBUG (null modem cable)
connections between plasma and System.
a) In the Type field, set the plasma model
b) In the Number of monitors field, select the number of connected plasma monitors
c) In the Mode field, select the default viewing mode from the pop-up menu.
!
First time “Plasma type” is selected (usually factory done), a particular
operations sequence must be followed:
1. Do not connect the system and the monitor by means of serial cable.
2. Select plasma type.
3. Once completed all initializations, switch off the system, connect the
system and the monitor by means of serial cable, switch on the
system: now is ready.
Viewing modes
Different viewing modes may change depending on used monitor characteristics .
Following viewing modes with corresponding short explanations refer to Pioneer
systems.
A) Automatic MultiScreen.
B) Fixed MultiScreen .
C) Automatic BigLittleScreen.