User manual

Operation and use

This section of the manual explains the basic functionality of the System.

It is assumed that the system is correctly installed.

First time equipment is switched on

ATTENTION !!! You have to insert SW licence enabling code (AETHRA

SOFTWARE LICENCE KEY)

First time the system is switched on, you need to:

1. insert the licence code;

2. Set some Location parameters

Licence code insertion

When the equipment is switched on for

the first time, the Licences page will

appear on the screen, and you can insert

the licence code.

Now several choices are available:

A) You can insert the licence code and enable it by pressing the Enable licence button.

B) You can going on using the system in TEMPORARY version by pressing the Start button;

Localization page will appear to set several important parameters (see “Localization” §) and you’ll

have 12 hours working time (switched on system time); once ended, system will stop waiting for the

licence code.

In the status bar, below time indication,

remaining working time is shown.

C) insert a DEMO licence code and enable it by pressing the

Enable licence button.

In the status bar, below time indication,

remaining working time is shown.

Note: to insert licence code after B) and C) choices, see the “Licences” §.