Installation manual

76
Managing the DataConference software
Data Conference is typically used when two ISDN, LAN, or NIC connected users decide to start a
conference using T.120 communication.
Start the DataConf.exe program.
The program creates an automatic connection between the System and the PC. At this point, several
items of information concerning the connection are displayed:
• The System IP address.
• The network interface used for video calls.
• The type of call: incoming or outgoing.
• The T.120 data channel active.
• The status of the NetMeeting connection between the two users.
Once the connection has been established, NetMeeting 3.xx is displayed in the foreground and you
can perform all data conference management operations.
If you desire to change the IP address of the System, you have to disconnect, press the key
“Configure” and enter the new address to use.
!
In the case of NIC conferences, it is necessary to configure one of the two users as Master by using the
special DataConf menu (in order to access DataConf menu click on
located at the top right of the
graphic displayed).