Installation manual

75
Data Conference with Microsoft NetMeeting 3.xx
The Data Conference software that has been introduced is compatible with version 3.xx of
Microsoft NetMeeting and allows you to connect via a LAN the System to a PC hosting
NetMeeting.
This enables a user on a local network to exploit the System as a kind of bridge in order to manage
T.120 videoconference data traffic on ISDN, LAN or NIC.
Download Data Conference
The file DataConf.exe is available for download on System web page, in the TOOLS section
described above.
!
It is important to download the file DataConf.ini as well. This enables automatic configuration of the
previous program and must be installed in the same folder where the DataConf.exe file was saved.
1. Download the software DataConf.exe;
2. Will be downloaded dc.exe file, start the file.
3. Download the software DataConf.ini
4. Start DataConf.exe.
Use of Data Conference
In order to use the System as a bridge for data transfer, navigate through the system menus as
shown:
1. Home Page
2. SETTINGS
3. AUDIO – VIDEO – DATA
4. DATA CHANNEL
Configure this section as illustrated:
1. Data Channel: YES
2. Modem: NO
3. MLP: T.120
4. Serial Rate: 115200
For uses over LAN, go to the following sections:
1. Home Page
2. SETTINGS
3. INSTALLATION
4. NETWORK INTERFACE
5. IP
6. H.323 SETTINGS
At this stage:
1. Check the box “Use NetMeeting”
2. Enter the IP address of the PC hosting NetMeeting.