Installation manual

72
Connecting a personal computer
The System can be connected to a personal computer either directly or via a network (LAN) in
order to update software, change remote settings or perform diagnostic tests.
Connecting a PC to the System without LAN
To connect the System to a personal computer not connected to a LAN:
1. Connect an Ethernet cable to the System connector and to the network interface card of your
PC.
2. From the home page, navigate through the following menus:
Home Page
SETTINGS
INSTALLATION
NETWORK INTERFACES
IP
IP CONFIGURATION
IP CONFIGURATION
Ensure that the System belongs to the same subnet as the PC, but has a different address. If
this is not true, change the System’s IP address and restart the system.
3. Start the browser on your PC. In the address bar, enter the System’s IP address. The web
page manager will appear.
Connecting to the System via a PC in a LAN
To connect to the System from a PC in a LAN:
1. Ensure that a LAN cable connects the System’s rear connector to your LAN. The PC can
be connected to a LAN node or to the LAN OUT connector at the rear of the System.
2. Switch on the System.
3. Navigate through the following menus:
Home Page
SETTINGS
INSTALLTION
NETWORK INTERFACES
IP
IP CONFIGURATION
IP CONFIGURATION
4. If your LAN does not use a DHCP server, leave the Automatic IP Address box
unchecked and enter the IP Address, the SubNet mask, Gateway IP Address and the
DNS Server IP Address supplied by the network administrator, then restart the System.
5. On the PC, start Internet Explorer. Enter the System’s IP address in the address bar of
the browser.
6. The web page manager will appear.