Installation manual

H.243 function

From the fullscreen page of MCU manager or a participant terminal is possible to get MCU control,

conforming to H.243 protocol, by pressing the BLUE key.

A page will appear, where is possible to:

• Request Chair control

 Close conference

• Send local on air

• For each terminal in the list

 Information: connected users

 See

 Send on air

 Disconnect

Remote terminals disposition and visualization

“Terminals disposition” icon

“Video Zoom +” icon

“Video Zoom -” icon

With MCU on and various connected terminals, is possible to choose disposition and how many

video flows should be displayed. From the fullscreen page of the manager, press right or left keys

to select the “terminals disposition” icon, and press OK.

Once the window is opened:

1. By means of up and down keys choose the visualization mode, then confirm selection with

OK key.

2. Close the window by means of the OK icon, or with the X icon to discard selection.

Note

If Continuous Presence transmission is enabled in configuration (see Multiconference setup chapter), “terminal

disposition” is sent to all terminals