Installation manual

• Master or Slave Cascade Role.

This option allows you to set up cascaded MCUs in a two-level hierarchy tree.

Corresponding to the base node of the cascade there is the Master System, with Slave

Systems for the child nodes.

Note

In a mixed-mode MCU session, the user can choose to substitute NIC protocol for ISDN. So in a multiconference

with an active NIC connection, no ISDN connections are allowed, and in a multiconference with an active ISDN

connection, no NIC connections are allowed

How to start a multiconference

To establish a multiconference:

1. From the Home Page, select the VIDEO icon, or press the “Call” key on the remote control.

You will enter the Audio-Video calls page.

2. Choose desired MultiConference type: MCU IP, MCU ISDN, MCU (mixed mode).

3. Chose the desired rate and number of participants.

4. If the MCU has not been configured, it is possible to enter the configuration menu

previously described by selecting the CONFIGURE MCU icon and pressing OK.

5. If the MCU has already been configured, go to the “Active Conference” icon and press OK

to start the multiconference. The same can be obtained by pressing the “CALL” key on the

remote control.

6. Local video will be displayed at full screen.

7. To add participants, press the remote control “CALL” key

8. To disconnect participants, press the remote control “DISCONNECT” key.