Installation manual

Installation

From the Home Page select:

1. SETTINGS.

2. INSTALLATION.

You will be prompted for a password.

The password is required to avoid accidental modifications and changes to settings.

Password

There are three different kinds of passwords:

Administrator password

: Always active. Can be modified by pressing the “EDIT” icon.

User password

: Must be activated. Can be modified by pressing the “EDIT” icon.

Phonebook password

: Must be activated. Can be modified by pressing the “EDIT” icon.

Note

The default value for all passwords is “1234”.

Encryption

From the Home Page select:

1. SETTINGS

2. INSTALLATION

3. ENCRYPTION

The configuration menu will be displayed; here you can set the following parameters:

Use Encryption

If encryption is activated, the System will use encryption in either H.323 or H.320.

It is also possible to enable/disable the encryption from the toolbar: select the padlock icon, and

press OK.

For IP calls

• If encryption has been activated, the data protection procedure is active from the beginning

of a videoconference.

Encryption is active from start (ISDN):

• If this option is selected, the System executes the encryption procedure from the beginning

of the ISDN connection.

• If this option is not selected, the ISDN connection starts in unencrypted mode. Encryption

can be activated later at any time during the connection. To do this, select the yellow

padlock on the status bar and press OK.

Unprotected calls

From this drop-down menu you can choose the policy the System will apply if the remote terminal

is not able to support protected calls.

• Disconnect – The System will not allow connection with a remote terminal that does not

support encryption, and therefore automatically disconnects.

• Ask Confirmation – During the session negotiation phase, the System will ask you to

confirm that you want to establish an unprotected call.

• Inform – The System will inform you that you are about to establish an unprotected

connection by displaying a visual warning message.

• State – The System will notify you that you are about to establish an unprotected call, and

once the connection is established an open padlock symbol will be displayed on the status bar.