Installation manual

37
1) Automatic MultiScreen
Selecting this mode, the system shows two side-by-side equal-sized pictures: graphics relating
to system management will appear on the right, whereas motion video will appear on the left.
Once connected, an XGA remote signal automatically changes the viewing mode to
BigLittleScreen mode; once in this mode, surfing inside menus will let back again to the
MultiScreen viewing mode.
To see a local XGA image select full-screen visualization, then you can switch to
BigLittleScreen mode by pressing the “C” key on the remote control.
Exiting from the FullScreen mode, the system immediately comes back to the MultiScreen
viewing mode.
a) Disconnected system.
b) Connected system (with 50” Pioneer plasma, you’ll obtain two 27” images, 4:3 ).