Installation manual

Plasma

Select plasma, type of monitor and viewing modality.

Note

Following instructions refer to “Pioneer” monitors.

Please carefully check XGA, Y/C and RS232C/DEBUG (null modem cable) connections between

plasma and System.

• In the “Type” field, set the plasma model

• In the “Number of monitors” field, select the number of connected plasma monitors

• In the “Mode” field, select the default viewing mode

from the pop-up menu.

First time “Plasma type” is selected (usually factory done), a particular operations sequence must be

followed:

1. Do not connect the system and the monitor by means of serial cable.

2. Select plasma type.

3. Once completed all initializations, switch off the system, connect the system and the monitor by

means of serial cable, switch on the system: now is ready.

Viewing modes

Different viewing modes may change depending on used monitor characteristics .

Following viewing modes with corresponding short explanations refer to Pioneer systems.

1. Automatic MultiScreen

2. Fixed MultiScreen

3. Automatic BigLittleScreen