Installation manual

29
Screensaver
• Automatic screensaver:
to enable/disable the automatic screensaver function, and to set its timeout
• XGA on screensaver:
Enable/disable XGA loop function: “XGA IN” signal sent to “XGA OUT.”
Two possible cases:
1. Active “XGA IN” signal: monitor shows XGA signal.
2. Inactive “XGA IN” signal: no signals on monitor (“Stand By” mode).
Remote control
• Numeric only remote control:
Enable\Disable alphabetical digits only on the remote control
• ID code:
In order to control more systems with only one remote control, you can assign to each
system a numeric code (01 to 99), and then consequently set the remote control.
• To configure the system:
a. The system code appears in the page
b. Is possible modify or save the new code.
• To configure the remote control:
1. Press the “RED” and “GREEN” keys at the same time
2. Wait for “Stand by” key stopping blinking
3. Insert the numeric code (01 to 99)
Call-Answer-Mode
General
This menu contains the following configuration settings:
• Mute
selected, at the start-up and after each disconnection system will not transmit audio, an icon
will be displayed in the local and remote terminals.
• Do Not Disturb
selected, at the start-up and after each disconnection system will not accept incoming calls,
an icon will be displayed in the local terminal.
Video Privacy •
Once in connection.
To activate the Video Privacy function, press the “VIDEO PRIVACY” key on the remote
control. Local video will no longer be transmitted.
The icon
will appear in the video window indicating that the remote terminal is no
longer receiving video from local terminal.
Not in connection
Activates/Deactivates:
Video privacy as above.
Do Not disturb System does not answer to incoming calls (busy for the remote)
• Confirm disconnection
Enable/disable confirmation requests for call disconnection.
• Enable Tones
Enable/disable tones in phase of call.
• Automatic answer:
Enable/disable the automatic answer function, after the selected number of rings.