Installation manual

System Configuration - Settings

This section describes the procedures to properly configure the System.

Note that some configuration parameters can be modified only when no connection is active.

User settings

From the “Home page” select:

1. SETTINGS

2. USER SETTINGS

The following page will be displayed:

From here you can access the following submenus:

• Control Panel.

• Call-Answer mode.

• Display Status Bar & Transparency.

• Customize colors.

Control panel

In these pages you can configure some system parameters.

Display

• Local Information:

If activated, shows information such as terminal name, ISDN number, and IP address on the

monitor in graphical form

• Warning messages:

If activated, allows visualization of “Bonding Recovery” messages

• Show logo when in a call:

Enables/disables logo display during a call. Logo is customizable—default is Aethra

S.p.A.

• Disable still picture:

Disable transmission/receiving of “still images”.

• TFTP server

Disable or enable and configure TFTP server (to obtain server IP address, please contact

your network administrator). If enabled, still images can be sent and stored in a TFTP

(Trivial File Transfer Protocol) server. These still images will be available for future use.