Installation manual

How to receive a call

If you are in the Home Page and receive a call, a notification will be displayed in a window

showing the caller’s number. If the automatic answer function (described in a later section) is not

enabled, you will be asked whether or not to accept the call. If you are in a different page, you will

be asked to accept or reject the call whether or not the automatic answer function is enabled.

Dual Video Mode

Dual Video Connection

You can create a Dual Video connection to send two video streams originating from different

sources .

This is feasible on the condition that the remote terminal supports Dual Video. Dual Video

transmissions can be initiated by either the Audio-Video calling or called terminal. If the receiving

terminal is set up with XGA output, and one of the received streams is an XGA stream, this one will be

automatically displayed into XGA output. However, the user is able to switch the automatic disposition

by pressing the “C” key on the remote control.

To create a Dual Video connection:

1) Set up a normal audio-video connection with the desired terminal

2) Press the “Dual” key on the remot control

3) Select the desired second video input source from the drop-down menu

4) Move to the YES icon and press OK

Once Dual Video is activated, if the receiving terminal is set up with two monitors, the user will be

able to see the two video streams simultaneously. If there is only one monitor, the user can switch

between the video streams by pressing the “SELF” key on the remote control.