Installation manual

15
System positioning and installation
!
All operations should be carried out without connection to main power supply.
Connection to main power supply should only be performed after complete parts assembly.
Place the System in the desired location, and connect the follow equipments:
1) Connect the microphone pole (see the cabling scheme Section A).
2) Connect the “Aethra POD” Microphone (see cable 1).
3) Connect System Audio/Video Ouputs to main monitor (see cable 2).
4) Connect Video Input.
5) Connect the LAN input to the network (see cable 3).
6) Connect the ISDN inputs to the network terminations. When connecting each ISDN access
to the system connectors, please take note of the corresponding telephone numbers ( see
cable 4).
!
Connect the ISDN input (ISDN connector or network interface) only to a network termination (NT1).
Do not connect the equipment to an external telecommunications line.
7) Connect supplementary audio or video equipments to the available inputs/outputs.
8) Connect the power supply (see cable 5).
9) Switch ON the TV monitor.
10) Press the switch on key on the System rear.
11) Wait for the main user interface to appear.
The system status LED on the front means:
LED on: System is on and normally operating.
LED flashing: System power is on, but the System is in “standby” mode.
LED off: System power is either off or not connected.