Installation guide

FS4104-AW – Installation Guide
7 / 31
WARNINGS
CAUTION:
Many of the components used in this device are sensitive to electrostatic charge.
In case of manipulation of the connection cables, disconnect the power supply and avoid direct
contacts with the connector terminals.
When handling electronic components, to eliminate any static electricity touch a grounded surface. If
possible, wear a grounding arm band.
Failure to comply with these warnings could cause permanent damage to device.
CLEANING
To clean the device use a soft cloth either dry or moistened with a little detergent. Never use any
type of solvents, such as alcohol or gasoline, to avoid damaging the finish.
CE MARKING
Hereby, Aethra S.p.A. declares that this product complies with requirements of the EMC
Directive 89/336/EC and Low Voltage Directive 73/23/EC, as amended by Directives 92/31/EC
and 93/68/EC, and (where applicable) with essential requirements and other relevant notes of
the R&TTE Directive 1999/5/EC.
The declaration of conformity maybe obtained from:
Aethra S.p.A. - Via Matteo Ricci, 10 - 60020 Ancona - Italy
www.aethra.com
- [e-mail]
FCC15 CLASS B COMPLIANCE
This equipment has been tested and found to comply with the limits for a Class B digital
device, pursuant to part 15 of the FCC rules. These limits are designed to provide reasonable
protection against harmful interference in a residential installation. This equipment generates,
uses and can radiate radio frequency energy and, if not installed and used in accordance with
the instructions, may cause harmful interference to radio communications. However, there is
no guarantee that interference will not occur in a particular installation. If this equipment does
cause harmful interference to radio or television reception, which can be determined by
turning the equipment off and on, the user is encouraged to try to correct the interference by
one or more of the following measures:
- reorient or relocate the receiving antenna
- increase the separation between the equipment and the receiver
- connect the equipment into an outlet on a circuit different from that to which the receiver is
connected
- consult the dealer or an experienced radio/TV technician for help