Installation guide

FS4104-AW – Installation Guide
5 / 31
SAFETY ADVISES
SAFETY RULES
To guarantee continuous protection for operator safety, only use the mains adapter supplied with
the device.
WARNING: for power supply connection use an easily accessible outlet located near the device.
Never remove the mains plug for permanent connection.
Connect the LAN port to an internal LAN circuit only. It is absolutely forbidden to connect the
system to an outdoor telecommunication line.
Connect the measurement cable of the telephone interface to the device connector and then to the
outdoor telecommunication line to avoid accidental contacts with live parts of the TNV circuits.
WARNING: never install the system during a lightning storm.
WARNING: When installing the device on the wall, do not fix it so that it can be removed in an
emergency.
The change from cold to hot environments can cause the formation of condensate inside the device.
To avoid malfunctioning, wait at least 1 hour before connecting the device to the supply mains.
In case of fire, absolutely avoid using water to extinguish it.
WARNING: RISK OF ELECTRIC SHOCK
The power supply used by this device involves lethal voltage levels.
Do not access internal parts of the device (and/or of the power supply unit).
If objects or liquids penetrate inside the device, immediately disconnect the power supply cable.
Before using the device again, have it checked by specialized staff.
Refer to qualified staff for service.
In case of intervention, always check that the power supply has been completely and successfully
disconnected.