Installation guide

FS4104-AW – Installation Guide
21 / 31
Enter encapsulation type and LLC SNAP
mode and click Next;
different parameters must be entered based
on encapsulation type (PPP, RFC1483,
etc.).
Enter the VPI (Virtual Path Identifier) and
VCI (Virtual Channel Identifier)
parameters for WAN1 (interface enabled
by default). This information can be found
in the contract.
If you select RFC1483 encapsulation
you must enter WAN-side IP address,
netmask and remote IP address
(Provider-side).
If you select PPPoA or PPPoE
encapsulation
you must enter User Name and Password
assigned by the ISP.