Installation guide

FS4104-AW – Installation Guide
18 / 31
Configuration
General information
Once you have made the connections illustrated in chapter 0, choose the configuration mode from
the ones illustrated below.
To configure FS4104-AW:
 if no PC with LAN board is available, you can use the console port and StarManager (software
included in the installation CD), as illustrated in § StarManager;
 if a PC with LAN board is available, you can connect it to one of FS4104-AW Ethernet ports
and carry out the WEB browser configuration as illustrated in § Internal WEB server
configuration with “Quick Start”.
If you connect FS4104-AW to an existing LAN you probably have to change the address assigned
by default to FS4104-AW (10.0.0.1) to make it compatible with subnet addresses used in the LAN.
In this case, after the initial configuration, continue as illustrated in § How to change the IP
address and connect the device to the LAN.
Less expert users can use the Command Line Interface (CLI) configuration through serial
connection and terminal emulation software
8
or Telnet session, as illustrated in “ATOS User’s
Guide”.
Connection to Internet
For quick connection to Internet with FS4104-AW, get the following information from your
Internet Service Provider and follow the instructions below.
The following information is needed:
 VCI and VPI value;
 encapsulation type used by ISP: PPPoA (PPP over ATM), PPPoE (PPP over Ethernet) or
RFC1483 (IP over ATM);
 User name and Password (in case of PPP encapsulation).
8
such as Windows HyperTerminal  .