User manual

42 SCOOP E-Z - User Manual 55 000 026 – Ed. B
This document is the property of AETA and can not be duplicated without authorisation November 2001
13. How to open a SCOOP E-Z ready for servicing
Tools required:
Philips Screw Driver (medium-sized)
The Scoop E-Z will be now separated into three Sections :
1) The rear metal panel
2) The bonnet
3) The casing lid
Steps :
- Switch to off Scoop E-Z
- Remove the external mains power cable if you use it
- Undo the two screws at the back.( under the metal rear panel)
- Remove the rear panel
At this stage, you can change the ISDN board, there aren’t fixation, the board is
just plug into a connector
- Undo the four screws under the Scoop E-Z ( located in wells ).
- Remove the bonnet.
Now, you have access to all internal boards.