User manual

28 SCOOP E-Z - User Manual 55 000 026 – Ed. B
This document is the property of AETA and can not be duplicated without authorisation November 2001
Note : In the case that you have 2 numbers, if you don’t enter the second
number, we call twice the first number.
A message to indicate that the call is in progress is displayed on the
screen.
Note :
- The number length is limited to 23 digits and may be displayed on 2
lines.
- Insert a “
*
” between number and sub-number in ISDN mode.
- Insert a “
*
” for wait in POTS mode
8.1.3. Re-Dialling the Previous Number
From the main menu, press “green phone” key, The last called number
appears on the screen, press again the “green phone” key. Actually, your
are in a short list of the five last called numbers.
"Call in progress" along with the redialed number is displayed on the
screen.
Note : We don’t re-load configuration, we use the last configuration used
( current now).
Note :
In case of mistake you may come back at the beginning of the menu by
pressing the "Esc" key.
Note :
As soon as the local and remote Scoop E-Z are connected, the
CONNECT result code is displayed.
If a connection can not be established, the NO CARRIER result code will
be displayed.
The bit rate is displayed in POTS mode.