User manual

14 SCOOP E-Z - User Manual 55 000 026 – Ed. B
This document is the property of AETA and can not be duplicated without authorisation November 2001
Format symmetrical
Connector 3-pin female XLR socket
Microphone powering Phantom 48V or 12V, Tonadder 12V
Maximum input level with pad +21 dBu
Input stage sensitivity adjustment +0 to +60 dB by 4 steps of 20dB
Input impedance
10 k?
CMRR >80dB @ 1kHz
Table 1 – Input interface
5.2.2. Outputs
The audio signal output is available on the two headphones and on the line level output.
Local audio from the inputs can be mixed with the return audio signal on each
headphone. The return audio signal is present in the headphone mix via the Local /
Return Mix Balance potentiometer on the front. ( See Figure 1 – Front panel, ref. 1 &
4).
By default, the return program audio is assign to the output line. You can assign local
audio program to the output by menu
1
.
Line Out Interface :
Format Symmetrical
Connector 3-pin male XLR socket
Maximum output level +16 , +10, +6, +4, +2dBu ( software
selection )
Output impedance
= 50 ?
Output symmetry > 40 dB
1
See audio menu section