User manual

55 000 026 – Ed. B SCOOP E-Z - User Manual 13
This document is the property of AETA and can not be duplicated without authorisation November 2001
- Pad switch ( for the microphone input, the input gain is adjustable by 4 steps of
20 dB )
- Microphone power selection switches
Dyn : dynamic microphone or line level
Phantom : phantom power supply ( 48V or 12V switch configuration )
T12 : “Tonadder” ( 12V )
Each channel can be applied a selectable 12 dB/octave high-pass filter (Off / 80 Hz /
120 Hz cut-off frequency) by menu configuration.
1
A LED indicates possible input overload ( see Figure 1 - Front panel , Ref. 11 & 12).
The gain of each input can be individually adjusted using the corresponding front panel
potentiometer ( Figure 1 - Front panel, Ref. 2 & 3 ) . When the potentiometer is in the
leftmost position, the associated input is muted ( –80dB attenuation ) .
If the limiter / compressor is enable in the menu, the mixed signal is processing.
Input 1
Mike pwr
PAD
Dyn/Ph./T12*
OFF/80/120Hz
0/-10dB
0..60dB
Fader 80dB
Overload
Lim/Comp
Input 2
Mike pwr
PAD
Dyn/Ph./T12*
OFF/80/120Hz
0/-10dB
0..60dB
Fader 80dB
Overload
Compress DSp
A/D
18 bits 48KHz
µ.c
µ.c
P.µ
µ.c : microprocessor command
µ.c
µ.c
Figure 6 - Analogue Inputs
1
See audio menu section