User manual

55 000 057 - B MIXY - User Manual 21
3.10.5. Information on the software
In the “Miscellaneous” sub-menu, move to “About”, then press “OK”
4 . The screen
will display information about the software (version, date, etc.). Press Esc to leave
this screen.
3.11. Save or recall a complete setup
The Memories sub-menu allows you to save all the current settings in a memory
(among nine available). From the main menu, enter this sub-menu by pressing the
“OK” key
4 . Move vertically the joystick to reach “Save”, then move it sideways to
select the desired memory number. Press the “OK” key to actually save the settings
into this memory.
Afterwards, the whole configuration can be recalled in a similar way, but using the
“Load” menu line.
Important notice : when switched on, MIXY recalls its settings as they were before
switching off. There is no need to use the memories for this purpose.
3.12. Programmable key
In normal operation, when not browsing the menus, the display is in monitoring
mode, and key
4 is a programmable function key. It can be assigned one of the
three following functions:
x “Boost”: 20 dB additional amplification for the monitoring (level meters
and headphone) of PFL signals (before channel faders).
This boost has no influence on outputs other than the headphone! In
addition, it is only operative on pre-fader signals.
x “Tone”: insertion of a test and alignment tone on the analog outputs
x “Slate”: insertion (on all outputs) of the signal from the intercom
microphone integrated in MIXY’s front panel.
To configure the key, enter the main menu, move the joystick to reach the “Func.
Key” line, and move the joystick sideways to get the desired assignment. On the
normal display a letter (B, S or T) appears to show that the corresponding function
is activated.