User manual

20 MIXY - User Manual 55 000 057 - B
3.10. Miscellaneous functions
3.10.1. Extension I/O selection
From the main menu, go to “Miscellaneous” on the scond page, then select
“Miscellaneous”; in this sub-menu, select “Ext I/O”.
Then select the desired routing for channels 2 and 3:
x “No inputs”: this is the defalut setting, where channels 2 and 3 are fed
from the Mic/Line inputs, and no signal is used from the “Ext I/O” inputs;
x “In 2 enabled”: channel 2 switched to select the input from “Ext I/O”,
channel 3 stays in normal mode (from Mic/line 3);
x “In 3 enabled”: channel 3 switched to select the input from “Ext I/O”,
channel 2 stays in normal mode (from Mic/line 2);
x “In2&3 enabled”: both inputs from “Ext I/O” are routed respectively to
channel 2 and channel 3.
3.10.2. Internal battery charge
MIXY includes a charger circuit specifically adapted for its internal Ni-MH battery.
Whenever a DC source is supplied, as a default the unit charges the internal battery
even while it is on. However, as charging draws up to 10 W power, it may be
desirable to prevent this, e.g. when using a limited capacity external source such as
an auxiliary battery.
To turn the charge off, go to the “Miscellaneous” sub-menu, then on the “Battery
charge” line move the joystick sideways to select the desired setting “Y” (charge is
active) or “N” (battery charge disabled).
3.10.3. Display brightness
Still in the “Miscellaneous” sub-menu, move to the “Brightness” option, then adjust
the brightness with sideways joystick movements.
3.10.4. Clear settings
Still in the “Miscellaneous” sub-menu, move to “Clear Settings”, then press “OK”
4 . This will bring all parameters back to a factory-default setting.