User manual
18 MIXY - User Manual 55 000 057 - B
3.6.3. Maximum level of the outputs, MOL
It is possible to set the maximum level of the analog signal for each channel of the
XLR5M (
16
) and mini-jack (
14
) outputs (this level is reached for a “0 dBFS”
level in the digital domain before the D/A converter of MIXY).
On the “Line” line of the “Outputs” sub-menu, push the joystick (
10
) to the right to
reach these settings, and set the MOL for the Left channel and the Right channels.
NOTE: The value shown is valid for the balanced XLR5M socket (
16
), but the
stereo mini-jack (
14
) provides the same signals in unbalanced format and 6 dB
lower.
3.7. Levels for the outputs to RF transmitters
On the left panel of MIXY, you can find a Neutrik 12-pin Minicon socket labelled
“EXT I/O”.
This socket includes two analog outputs provided to feed two RF transmitters (or
one stereo transmitter). These signals are the same as those found on the “Line Out”
socket, but they are unbalanced and their level can be adjusted separately.
The levels are set like for “Line Out”, between -40 and +14 dBu.
3.8. Parameters of the digital outputs
The digital audio signals (24 bit) are available on two outputs, one electrical and
one for optical connection (Toslink). The sampling rate is selectable as well as the
format.
3.8.1. Selection of the sampling rate
By vertically moving the joystick in the “Outputs” sub-menu, go to the “Digital”
line then to the sampling rate selection. Press “OK” (
4
): the displayed sampling
rate blinks. Move the joystick to display the desired value and confirm by pressing
the “OK” button (
4
).
3.8.2. Selecting the mode of the digital outputs
While still on the “Digital” line on the “Outputs” sub-menu, go to the selection of
the mode, and press “OK” (
4
): the mode blinks.
Move the joystick left or right to select between the “Pro” or “Consumer” mode.
Confirm by pressing “OK” (
4
).