User manual
14 MIXY - User Manual 55 000 057 - B
3.4.1. Input routing
The signal from each input can be routed to the mix buses, on left, right or center
(routing to both buses, with same level), and it can be left unrouted.
NOTE:
x
When the “Stereo” mode is selected for inputs 1 and 2, the routing of these
inputs automatically becomes Input 1 to Left, Input 2 to Right.
However, this can be manually overriden!
x
In contrast, selecting the “M/S” mode for inputs 1 and 2 forces the
following encoding and routing:
“M+S” (= 1 + 2) to Left bus, “M - S” (= 1 - 2) to Right bus
No manual routing is possible as long as the inputs are set in M/S mode.
3.4.2. Input gain setting
Using the joystick (
10
), move the highlight to the gain setting on the desired
channel, and select it by pressing the “OK” button (
4
). The gain is adjustable by
10 dB steps from 0 to 50 dB. Confirm the choice by pressing “OK” (
4
).
NOTE:
x
Conventional stereophonic microphone couples normally have matched
sensitivity. For more convenience, MIXY automatically links the input
gain of channels 1 and 2, so you only need to set this gain once for a stereo
couple.
x
On the contrary, the transducers of a M/S couple may feature different
sensitivity. For this reason, no link is done in this case, and you can freely
set the gain on the two channels.
Remember that in the M/S mode, the organisation MUST be M on channel
1 and S on channel 2.