User manual

8 MIXY - User Manual 55 000 057 - B
To compensate for such situations, it is possible to use MIXY’s “monitoring boost”
function, that provides a 20 dB gain increase on the headphone when a pre-fader
source is selected. This function can be instantly activated or deactivated using the
programmable push-button (
4 ), and its status is reminded by an icon on the display.
Note that this boost is only active for pre-fader sources; this avoids a too loud
listening when you switch the monitoring back to other sources!
2.5.1. Display screen
The display screen of MIXY is a blue OLED graphic display. This technology
features a very wide viewing angle and fast response time. The display brightness is
adjustable.
Two main display modes are available:
x “STD”: this is the standard 2-channel display mode, showing the audio
level of left and right signals; at the bottom of the display, icons recall the
settings of the Mic/Line inputs regarding: microphone powering, high-pass
filtering and phase (polarity).
x “FULL”: same as the above, but in addition the level of the three mixer
channels is shown, after the channel faders but before routing to the mix
buses.
Levels are displayed on large scale bargraphs covering -50 dBFS to 0 dBFS. They
are measured with fast PPM ballistics. In addition, peaks are held on for about 1
second (“peak-hold” function).
An “OVL” icon shows up whenever the level reaches -3 dBFS or more.