Instructions
E. sales@aesglobalus.com
www.aesglobalus.com
T: +1 - 321 - 900 - 4599
Changing Radar settings
NOTE: Only available for EL00C-RAD and EL0IC-RAD versions.
Please contact the technical department before altering any
radar settings, doing so may cause the e-Loop to be unreliable.
1. The first setting is Release Trip – this is what the magnetic
field value needs to drop below to trigger the radar to take a
reading which verifies the vehicle is no longer present. 300
is the default setting and should not be changed before
contacting the technical department.
2. The second setting is Start Lens – this is the distance the
radar will start detecting. 200 is the default setting and
should not be changed before contacting the technical
department.
3. The third setting is Measure Lens – this is the maximum
distance the radar will detect a vehicle. This can be adjusted
depending on the types of vehicles being used and the
location of the e-Loop.
4. The fourth option is Radar Trip – this is used to adjust the
sensitivity of the radar. The higher the number, the less
sensitive it will be. 500 is the default setting and should not
be changed before consulting the technical department.
5. The fifth option is Radar Confirm – the default is OFF when
turned on. The sensor will detect the vehicle with magnetic
field detection and will then confirm with radar before
sending Open command.
Radar settings:
1. After making connection, scroll to Radar Settings and press
the SET button.
2. To change any of these settings, navigate to the desired
option using the UP and DOWN buttons, and press the SET
button to select option. Again, use the UP and DOWN
buttons to change the setting and press SET to confirm.
3. Once all changes have been made, press the UPLOAD
button to upload the new settings to the e-Loop. If
successful Setting Applied will display, if not it may display
Connection Fail – if this occurs, try again.
NOTE: Lowering the range for an undercover car park where
no trucks can enter can extend battery life. Extending range
for a trucking depo may be needed for high trailer detection.