Instructions

E. [e-mail]
www.aesglobalus.com
T: +1 - 321 - 900 - 4599
To code e-Loop first option
1. Press and release CODE button on the Transceiver, the
Code LED will illuminate.
2. Now press the CODE button on the domestic e-Loop, or
use the magnet to activate the code button on the
commercial e-Loop. The Transceiver and e-Loop will
now pair. If pairing was successful, the Code LED will
flash 3 times and exit code learn. If pairing fails, the RX
LED will flash 3 times and exit code learn.
To code e-Loop second option
1. Place the antenna of the Transceiver on top of the e-
Loop.
2. Now press the CODE button on the Transceiver. If
pairing was successful, the Code LED will flash 3 times
and exit code learn. If pairing fails, the Code LED will
stay on as per the standard coding sequence.
To change operational mode
1. Remove the power from the Transceiver by
unplugging the terminal block.
2. Now hold the CODE button on the Transceiver, then
plug in the terminal block. The Menu LED will
display. Now release the CODE button, the Code LED
will also display indicating Pulse mode.
3. To change mode press CODE button, the Menu LED
and RX LED will now display indicating Hold mode.
4. Press CODE again and all LEDs will display indicating
Latch mode. (By pressing the CODE button again, it
will take you back to Pulse mode). Wait 5 seconds
and the menu will exit back to operational mode.