Specifications

40-7170 Revision 2B July 6, 2012

2.0 Safety Considerations:

The following items are safety related precautions that you should take into consideration

when installing your AES IntelliNet system. They are for your safety as well as others

and the safety of your equipment.

• Use caution when installing antennas to keep them away from electrical wires which

could cause serious injury or death if antenna makes contact with live wires.

• All equipment must be installed in accordance with National Electric Code,

applicable UL Standards and local building codes.

• Be certain to properly ground the antenna and surge suppressor to help dissipate

surges away from equipment and personnel. The grounding of the antenna and surge

suppressor is for your safety and the safety of your equipment and should not be

neglected.

3.0 Environmental Considerations:

The following environmental related suggestions are to help insure an installation that

will provide you with a system that will operate at its optimum long into the future.

• The provided AES 52-0054 surge suppressor should be installed in a weather tight

enclosure such as a UL Listed NEMA4 enclosure.

4.0 Technical Specifications:

Listed below are the technical specifications for the 7170 IP-Link Transceiver.

• Transformer Input rating is 16.5 Volts AC at 40/45VA

– Use only provided Model Amseco XF-1640 or ELK P/N ELK-TRG1640 or TDC

Power P/N DA-40-16.5 or MG Electronics P/N MGT1640

• DC Current Draw: 370mA standby, 900mA transmit

• 7170 DC operating voltage

is 12 Volts nominal.

• Onboard Fuse; Self

Resetting / Not User

Serviceable

• Rechargeable Gel Type

Battery Required:

12V, 10AH

• Low Battery Condition, AC

Fail and Charger Trouble

are reported to Central

Station.

Figure C –

Enclosure Dimensions