Specifications

40-7170 Revision 2B July 6, 2012
24
C.3. Set Up Menu:
There are several methods to access the Setup Menu using a terminal program attached to
the Console port.
• One is to reset the IP-Link and press “S” following the prompt:
“Type Setup Key within 3 Sec. For Setup Menu”
• During normal operation, when the Modem is not selected for testing or backup
communication, press “S” plus <Enter>.
Once the Menu is displayed you press a selected highlighted letter and then press
<Enter> to modify its associated parameter(s) or access the function.
Figure P – IP-Link Setup Menu
Functions accessed by pressing I, and Primary Server half of S, T and P are also
configurable using the UCMD command mentioned in C.2.
I: Modifies the 8 digit Hexadecimal IPLinkNode ID of which the last four digits is the
ID reported for this device. It must be unique in the network. This ID is also passed
to the attached RF Board. You must include the leading four zeroes.
R: Resets the IP-Link. There is up to a 70 second delay as the unit waits for the
watchdog program to initiate the reset.
S: Modifies Primary Server IP1 and Backup Server IP2 addresses for the Primary and
Backup (Secondary) MultiNet Receivers.
T: “Server Port1” and “Server Port2” IP port numbers used by the receiver that allows
the IP-Link Transceiver to connect. Default is 7070
P: Modifies the “Primary Modem Server1 Phone#” and “Backup Server2 Phone#”
numbers that the IP-Link Transceiver will call if TCP/IP fails.
The modem feature has not been evaluated by UL.
M: Forces a test of the modem. Same as is automatically run at program start and daily.
D: Displays a scrollable log with the results of the last modem test.
W: Runs tests on the power supply. Follow prompts on display.